DEAR ALL
I have motors ( 10 units )each one is 90kw 380V 50 HZ 1000rpm
but new local pwer is 220v 60 hz
requierd rpm should be 1000
pleas what the beast solution is used frequncy converter or
rewinding all motos or chang all motors
thanks
Answer Posted / k m sarafuzzaman
We Have to instolation A step up transfarmer.
Is This Answer Correct ? | 1 Yes | 5 No |
Post New Answer View All Answers
What is the phase relationship between the primary and secondary voltages of a transformer?
how does this job compare with others you have aplied for?
How RTCC panel is working and give single line diagram for RTCC with transformer?
Why ground terminal is used in pot meter 10k ohms
high voltage transformer input voltage,current and amps rating..distributed transformer input voltage,current and amps rating...
Difference between shunt, PMG and AREP excitation. Which is the most reliable between PMG and AREP.
In HI POT test what is reason for applying the AC VOLTS and DC VOLTS in different applications what is the nessesity for this ?
Why armature rheostat is kept in maximum position?
Why do we require transformer with less specific weight if supply frequency is increased?
how to minimize earth resistance upto 2Ω, if the resistance is 6 Ω ?
why we use circuit breakers for switching instead of normal switching device?
Hi guys! Plz help me to answer the following questions. 1. What are the types of transmission line energy losses? 2. Why are the VLF are used some types of services? 3. What frequencies are used for reliable beyond the horizon terrestrial communication without repeaters? 4. To permit selection of 1 out 16 equi-probable, what is the number of bitis required? 5. What is the most common modulation used for telegraphy? 6. What is the multiplexing is used to increase the capacity of the optic fiber? Thanks
Earth is a conductor or load?then ammeter connect to 3- phase supply,it shows the measurents or not?
Best way to measure the Soil resistance of rocky soil, three probe method and four probe method
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5