Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / vikadent
As a rule of thumb, the optimum loading is between 50% to 70
% and my reference is Electrical installation guide by
Schneider and this is the range where the losses are minimum
inside the transformer.
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
Please explain the following and how these are working with PLC unit 1.I/O Module 2.I/O Device 3.Adaptor Card 4.Ribbon Adaptor 5.RS 485-FC
What is a advantage of Self Reset Lockout ? On Fault breaker get trip & fault no longer exist then self reset lockout how inform us?
what is reactive power?, why its measured in VA ? is it transient behavior of system?
What is the Basic Difference bitween Long Shunt Connection and Short Shunt Connection in DC Generator?
how to read idmt curva
What are the types of transformers according to the arrangement of iron cores?
armature winding of dc machine produce alternating emf then it convert in to dc by using commutator.But only we consider armature resistance why don't we consider inductive reactane effect?
I have two PLC processors. I want to communicate both processor with each other. How i can do so?
Why Utility Distribution System in India is mainly at 11 kV? Why not Utility go for 33 kV?
what is meant by vector group of a transformer? How can it be derived?
I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?
What is the power factor of an alternator at no load?
earth also having a gravitational force (magnetic field of north and south)but it attracts any object compare to this theartifical magnetic cant perform same as earth why?
if voltage bt phase & nutral is 38v in a panel board . whats the root cause.
hi frnds what is meant by harmonics & what is meant by third hormonics,where its will occur ?thank u
