we can stepdown the voltage from 230/12v ,and we use the
voltage for various electronics components why can't we
step up the voltage from 12/230v if we can shall we use the
voltage for domestic single phase supply
Answer Posted / michael
we can step up 12v to 230v but we cant use it for domestic single phase supply . we all know that V1/V2 = I2/I1
the amount of current comes from electronics device will be lower when we use step up again the voltage to 230v. you will attain the 230v but not the current needed by the equipment
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are the components of feedback control system?
when will be the iocl interview results i faced interview on 8th september 2008 iam from electrical branch i faced interview for the post of electrical engineer??????????????????????//
What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.
IF TVM OF TRANSFORMER SHOWS POWER FACTOR ON 33 KV SIDE AS 0.97 LAGGING AND ON 132 KV SIDE IS 0.75 LEADING.IS THIS CORRECT.WHERE IS PROBLEM.
What is slip in an induction motor?
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
Draw a circuit diagram in which if button is open we can use socket and bulb as a series test circit and if button is close than simple we can use socket as any load purpose.
Define ampere
how cables go in and come out for distribution from the feeder pillar box?
features of hbc fuses
What are the effects of adding a zero to a system?
Why the dc voltage drop during starting of emergency lube oil pump? The Voltage drop from 135kv to 125 kv for one min. before re-establish to 135kv?
The 3 phase 400 hp 440 volt slip ring induction motor do not take one phase amps why ? The motor is running good condition
What are the main advantages of bode plot?
can i connect wavetrap in 2 different phase in EHV line?