Answer Posted / bala murali
By using DP txr for Calculation of Flow we are enable squre
root in Txr.
This is bcoz the flow is directly proportional to square
root of Diff. pressure b/w HP and LP.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
i want to find out iffco get test paper
who's take first position in process in the timing of new installation flow transmitter and control vavle. give the answer with logical trick.
1. what is modbus cable? 2. what kind of communication we are using for the interface of DCS, ESD and Third party cabinets? 3. What is serial communication and peer to peer communication?
where proximity sensor installed on tank in loading arm application
Explain bernoulli’s theorem. State its application.
I have 0.75mm sq multicore cable (IS type) , can use instead of same type but 1.5 sq mm cable ? Note : The distance is around about 150 meter.
A flange is used for instrument connection for a system with a design temperature of 316C (600F) and a design pressure of 1000 kPa (145 psi). What is the class rating of the flange to be used for this application? Explain your answer
dear friends, i have seen flow as the selection critriea in presure guage (bourdon tube) and i would like to know what is the relation between flow and performance of pressure guage other parameters i found in the data sheet are pressure max. 1ksc temperature max. - 50 deg c line size - 80NB operating range - 1ksc pr. guage range - 0-2 ksc thank u,
how to calibrate and troubleshooting of leveltroll?
few questions on RS 232,1 question on relationship of impedance and turns ratio, many questions on flowmeters
how radio frequency level probes works with its controller ? what is its principle ? pls give me brief explanation?
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
What is the difference between mmwc and mmwg?
Name different parts of a pressure gauge. Explain the use of hair spring in the pressure gauge.
Explain why plc require in analog input 4-20amp & 0-10 volt?
