how to choose the cable rating for load (KW)? EXAMPLE.50KW load
- 14 Answers
- 168270 Views
- ACC, NCUI, Polycab, PowerSol, Siemens, SW, I also Faced
- E-Mail Answers
Answer Posted / ajith
380V/50HZ,50KW=4core50mm
| Is This Answer Correct ? | 12 Yes | 9 No |
Post New Answer View All Answers
in science exhibition how lamp can blink when you clap near the lamp ? thank you
Define the three phase formula fuse.
hey guys i scored 910 on GRE and 67 on TOEFL respectively.I have an aggregate of about 74%in my B tech.For which colleges should i apply for an MS program in electrical engineering.I am looking for colleges in NJ,SC,NC,GEORGIA, NY. Please reply with a good response.....
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
describe the phenomena of vacuum interruption in C.B
What is the lifetime of a Thyristor? Is there a recommended lifetime for thyristors after which they should be replaced?
how generator avr give to the input?
What is dc current source? Differentiate between ideal and non ideal current sources?
please give me all the Alarm .Trip ,Safety Relays & Conditions of UPS Systems mail me on ashokbabunhce@gmail.com
we have 3.5MVA-11/6KV transformer. how can we calculate earth fault current and NGR calculation?
Why electrical power generation and transmission done in 3 phase system not more than 3 phase ?
How it can worked plc based electrical system And which type of software using.
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
Zone of protection and tripping scheme of arc protection relay.
where was current transformer protection units used and why??
