Answer Posted / thran
motor value check from.... body to phase Then winding to winding phase came infinite using megger 1 kv r 500(dc volt megger came ohm value...
| Is This Answer Correct ? | 10 Yes | 2 No |
Post New Answer View All Answers
what is calculation mathod/formaulla for deciding Size of busbar (Copper/ aluminum)for L.T. panel on Various Fault level like 50kA,25kA,10kA
what is capacitor voltage transformer?? how it is different from potential transformer?
Hi,I am working in abroad for more than 3 years in a company operating with 11kv and 6.4 MW power. I need c licence in India,can I? some other says only i can get if i work for 2 years in india only! anybody kindly clarify by doubt.Thanks
If there is major % of Voltage harmonics in the system, how can it be control or reduced?
what the principle of sincroscope?how it works?when it needed?
what is earth-fault?when it occurs? to check where it occurs what type of test should we do?
In the Variable Voltage Variable Frequency Drive, how the Voltage and Frequency varied ? Is it varied in the Inverter part of the Drive ? Please give us supporting document if any.
how can i determine the KVA/MVA rating of transformer precisely?? is there any standard test?????
How do we find the rating of a transformer, if it got burnt badly.
What is s-domain and its significance?
What tests should i carry over on a newly rewinded DC Generator with voltage rating of 38 volts and current rating of 350 amps, to certify that the machine is OK?
On what basis do you decide the ONAN (Oil Natural air natural) or Dry type transformer for a project?
Can anyone please provide me details of MCCB/Contactor/SFU rating calculations for a motor feeder..for example 50 kw.. not from type-2 cordination chart. i want manual calculations..
which connection is safer series or parallel?usually which connection we prefer at home?
hi I have done 3 yrs diploma in electrical engg after 10+2. I have 16 years of work experience into design proposals sales and engg application development in LV/MV swithcgear and sub station automation field. I want to apply for immigration to new zealand but I am not sure whether I qualify or not since I dont have a degree. Can anyone advice? Thanks Riz
