which element is neglected during fault calculation?
a)resistance
b)inductance
c)capacitance
d)reactance
- 4 Answers
- 6633 Views
- I also Faced
- E-Mail Answers
Answer Posted / wareagle
Resistance and inductance are the most important values used
in the calculation. C is usually ignored.
| Is This Answer Correct ? | 1 Yes | 7 No |
Post New Answer View All Answers
how circuit breaker work.. what is the operations taking place inside a circuit breaker when an overcurrent occurs... is it similar to fuse?
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
The screw thread commonly used for transmission of motion is one of the following types of threads
how i chosse capacitor bank if my energy meter is 48 kvr? tell me capacitor bank chossen formula?
what is the difference between electrical choke and electronic choke?
After completing iti in electrician, how can i get certificate of electrical supervisor? What ia requirements. For it?
What are the advantages & disadvantages of a group electrive drive?
at meter room 50 hrc switch installed,but there are not get earthing proper,so what happen?and 11kv transformer out put going in to hrc main 400a three nog each? so earthing is require for all switch? (some customer made earthing at there home.)
In a large office how do we calculate required number of light fittings, assuming fittings are 4x18W or 2x36W fluorescent fitting ?
what is earthing.how we make it,describe briefly.
How to see the inductance in a transmission lines
The ripple frequency in output of fullwave bridge rectifier is a. Half the input b. Twice the input c. Same as input
what is the earth current,reverse power,electrical trip generator short circuit,low voltage, high voltage please discribe me
what is servo motor & how does it work.
If only R Phase is connected in 2 pole elcb, n is not connected than it will work or not in ground fault.
