in 11kv/400v transformer when only one phase of 11kv supply
fails what happens to sec voltage and why
- 6 Answers
- 14006 Views
- I also Faced
- E-Mail Answers
Answer Posted / technical1210
11kv/415v T/F is designed for 3 phese supply , if 1 phase
fails then t/f will trip automaticly and no voltage will be
avaliavle at secondary side.
| Is This Answer Correct ? | 11 Yes | 17 No |
Post New Answer View All Answers
What is the formula to calculate distribution transformer De-rating on iron losses basis
1.what is the difference between ct and cvt? 2.what is the difference between pt and cvt? 3.what is the difference between relays and circuit breakers?
HOW TO CHECK THE VECTOR GROUP OF A TRANSFORMER YD11?
what is the physical connection of a analog i/p to a analog i/p module (ab plc)and through a analog o/p module(ab plc) to a analog o/p . and how all the process control by scada
what is the isolation transformer. what is the isolator?
why are the maintaine power factor and how can this control and this is how work.
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
How to find ampere on ht side for selection of cable size ???
If we impress a dc voltage of 230 V on an unloaded 230 V, 50 Hz transformer it wi A give high secondary voltage B burn out C give secondary voltage as per K D none of these
being an electrical engineer why you wanna come into software i have an very good academics what answer i have to give
What is the difference IN MCCB's between thermal magnetic and electronic tripping system ?
What is the difference between Delta & Wye windings?
how to calculate the mesh earth network resistance in such substation, is there any recommended resistance values with references , thanks!
What is the formula to calculate the rating of a three phase air circuit breaker
What is online and offline ups? how does it works?
