125Kva Dg can take up how much amphere load.
- 7 Answers
- 35994 Views
- Indian Railways, I also Faced
- E-Mail Answers
Answer Posted / shridhar awasthi
125 kva dg will take 173.90 amps on 100% loading and 191.29
amps at 10% over loading according to I=KVA/sqrt3*voltage
| Is This Answer Correct ? | 13 Yes | 4 No |
Post New Answer View All Answers
how the aircraft outer body and inner body is separated ?
In the Variable Voltage Variable Frequency Drive, how the Voltage and Frequency varied ? Is it varied in the Inverter part of the Drive ? Please give us supporting document if any.
What is an alternator impedance value?
what are safety measures in /control in diesal engine/ explain them?
why single CT used in DOL starter power circuit?
What is the de rating factor of cable? What is the importance of the de rating factor in cable selection?
While testing a ZCT what parameters have to check or measure?
Shall I use 40A semiconductor Fuses in 32 A SFU ? Frame size is same. What Happen if Fuses burn on SFU?
HOW WORK HEAT PLATE EXCHANGER
What are marginally stable systems?
How LT megger works ?
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
Which are resistive loads & which one are inductive loads : Refrigerator, Split air conditioner, ceiling fans, well pump, fluoresecent bulbs, T.V, CRT Monitors, Adsl Routers, C.P.U, Printers, Deep Freezers, Speakers, DVD Players, Microwave oven etc. ? Output Power for these Appliances Would be same like this : P = V * A * P.F Or would be changed ? thanks
If we want to change a contactor of faulty one what are the conditions want to fullfil
State superposition theorem?
