Answer Posted / sheo
Suppose LOAD-1000 KW
So design load of Genset @ 80% inefficiency.
and power factor @80% in case of ( Failure of capacitor)because life of Capacitor and Gen set never equal to each other.
so 100% power back-up for 1000 KW load required DG 1000/0.64=1562.5 KVA
Recommended DG-1500 KVA
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
what is the saturation point of crgo lamination.
Define average demand?
Motor,transformers,capacitor tubelight etc....
what is mean by dual digital protection in the relay field?
Single line diagram for dbb (double bus bar)system.
what is the purpose of shading ring or shading coil in electrical equipments.
At what factor resistance r of a conductor depends?
how to identify the cable quality and what is flame proof cable
Why the dc voltage drop during starting of emergency lube oil pump? The Voltage drop from 135kv to 125 kv for one min. before re-establish to 135kv?
What fomula is used to calculate: 1. rated frequency withstand voltage, and 2. rated lightning impulse withstand voltage.
What is the relation between frequency and motor rpm?
Is a direct shorth ciruit on a branch MCCB in a Low Voltage Switchboard a correct means of tesing the performance for discrimination?
when will be the iocl interview results ifaced the interview on september 8 th
r we are using in gas turbine mark (5) frame (6) (made in india Bhel 1997) Ā
How to calculate the sag on transmission Lines.
