For a certain load i need 100kw load ,In that case what
rating mccb should i use?
- 5 Answers
- 11592 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajat
for 100 kw means 100000watt
use formula p= vi
100000= 230xi
i=100000/230= 430 amp
we always use current rating of the mccb is 1.5 times of full load current so we can use 430x1.5= 645 amp
| Is This Answer Correct ? | 5 Yes | 4 No |
Post New Answer View All Answers
What is BusBar integrity test and how it is conducted?
Formulae for calculating the transmission line losses for different voltage levels
I HAVE A 50A MCCB AS PER DESIGN LINE WIRE CONNECT UPWORD SIDE AND LOAD IS CONNECTED TO DOWNWARD SIDE TO THE MCCB.IF NOW ANY ONE CHANGE SUPPLY & LOAD(WISEVERSA) WHAT HAPPENS ? DOES MCCB OPERATION OR WORKING FUNCTION NORMAL IF YES THAN WHY THERE ARE MARKED LINE & LOAD ON MCCB.
how to design the heater in temperature control unit to heat 50KL of water?
why and where we use early make & late break contacts in protection?
Distinguish between nuclear power station with thermal power station for initial cost, starting period, cleanliness, and transportation of fuel
Direction of flow of active power and reactive power with logic?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
how technical is calculated in 11kv line and lt line
why it is not advisable to run low rating (19KVA) DG sets in parallel for long durations even though they are provided with droop ckts (QDC)
what is RFID? thire application;
For R-L or R-C ckt,time constant formula is L/R and RC respectively and its unit is in sec.Pls tell me the derivation
Starting Time of LT & HT Motor
what id a dry type transformers and its function ?
what will happen if multimeter(selector switch at DC voltage) and terminal at current is connected to DC supply?
