If Solenoidal valve works in manual mode but not in Auto
mode. What should be the problem?
- 8 Answers
- 9508 Views
- Bharathi Cement, Titanium, I also Faced
- E-Mail Answers
Answer Posted / raja
Need to be check the DCS I/O cart the DI cart digital output cart some time give fault signel the I/O cart malfunction
| Is This Answer Correct ? | 4 Yes | 4 No |
Post New Answer View All Answers
What is heating effect?
field bus transmitter calibration procedure tell me
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
I have completed B.E. Instrumentation & control in 2009. i have 3 year industrial job experience in chemical plant.now, I want to join M.E. in external. so, Plese say easiet way and good institute name.
what is sil (safety integrity level
Explain about the leakage class of the control valves
If we increase only P what will be controller action ?
What is the constant voltage unit?
what is the electrical operation procedure for switching on 27.6MVA electric furnace.
How we calculate orifice plat size???
what is zero and span ?
plz send me general of ongc
can any one explain in which term we are flow flow is it volumetric r is it mass? and y
Which is your favourite subject & explain any one topic of it.
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
