why the rating of transformer in only KVA not in others?
- 7 Answers
- 7096 Views
- I also Faced
- E-Mail Answers
Answer Posted / khalid
because of transformer winding losses
winding loses are a reactive power reactive power is add
in active power so the rating of T.F in KVA
KVA = Apparent power
KVA =KW+KVAR
Apparent power =Active power+reactive Power
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What is trip and closing coil in cb? Why need of them
How Diesel Generator start ?
I use 20 nos led tube 4feet, in pathway 100mtr approximate, so what size cable i use for lighting
If increased the frequency up to 1000 then what changes shows in voltage?
what is allowable ac mixing in dc
How to prepare electrical preventive maintenance plan & shedule of machine tools in manufacturing unit.
while starting a liquid starter ,is there any volage drop on water/soda on tank.can we touch the tank on starting?
7- What is the Dissipation Factor and the difference between it and Insulation Resistance Test? 8- What is the task (function) of DC and AC reactors in power plant? 9- What is the task (function) of (open delta with earthed) in some types in transformers? 10- What is the base of the selection of the vector group in transformers? 11- What is the zig-zag transformer and its function by drawing in large detail? 12- What is the polarity ? 13- Why we make short between phase(R) in high side and phase (r) in low side in vector group test? Where High Side ( R ,S and T ) and Low Side ( r ,s and t ). 14- What are the time on delay and time off delay? 15- What is the vector group? 15- What is the task (function) of different types of vector group such as Dyn11 , Dd0 , YNd1,……..,?
What is measurement?
While HT line put on to activate ACB in low tention panel VCB tripping instantly.why it happens
Sir,In our company there are 3 caterpillar make(capacity:(1) 3.3KV,2.5MW(2)3.3KV,2.5MW & (3)3.3KV,1.9MW) & 1 deutz make (capacity:11KV,3.8MW)gas engines utilised,all are running in paralell. There are three transformer utilised,(1) 6.25MVA,3.3KV/22KV,Impedence voltage:6.7% used for two generator,both are 2.5MW(2)5.5MVA,3.3KV/22KV,Impedence voltage:7.2% used for one generator of 2.5MW & (3) 5.5MVA,11KV/22KV,Impedence voltage:7.8% used for one generator of 2.5MW.all generator breakers capacity of 1250Amps. Sir,I want the details of fault level calculation of generator,transformer individually & for whole system. If you require any information from me.feel free for contact me sir.pl.send the answer of my question as the earliest as possible.
What are the classifications of oscillators?
What are the causes for the failures of sandwich type (Al) busducts?
operation of protection relay watchdog contact?
if flux and load static in dc motor and supply voltage increases 20% then what happened in speed
