Interested to Buy Any Domain ? << Click Here >> for more details...
I want to know what must the CT ratio be on a load of 300A
is a 3PH nutral to earh installation?
- 4 Answers
- 6011 Views
- I also Faced
- E-Mail Answers
Answer Posted / wareagle
600/5 would work nicely. One on each phase.
| Is This Answer Correct ? | 3 Yes | 4 No |
Post New Answer View All Answers
what is LSR?
how dia of wire and angles are calculated for overhead shielding wire to protect substation equipment from lightening strokes???
what happens to the water pump if ground water level is slowly decreasing?our water pump is varying from no-load full-load due to this problem
What type of wiring series or parallel is used for conventional and addressable type FAS & why?
IN MY SYSTEM THERE IS ONLY OVER CURRENT EARTH FAULT RELAY IS AVAILABLE. FOR THE UNBALANCE SENSING IS THERE ANY RELAY IS AVAILABLE? THE SAME CTs WHICH ARE USED FOR THE OVER CURRENT EARTH FAULT RELAY CAN USE FOR UNBALANCE ALSO?
What is the difference between single point and double point bonding. please kindly detail about bonding of cables.
The slip during plugging operation is given by= A 1-s B 2+s C 1+s D 2-s
how to select the double earth conductor if 21A full load?
write a c++ code that receives an integer number and display the sum of the number and its revers integer?
We have 250 KW x 2 motors, which are load from 25% to 100% varying load in every minute , so how can we compansate the power factor. pl give your opinions on the above subject.
what is the difference between transformer,converter and transducer
If we need 4c× 50mm sq cable but it's not available so we can pull 4c×25mm sq two cables?
What is referred to the electron in the outer orbit?
if voltage bt phase & nutral is 38v in a panel board . whats the root cause.
What type interview questions ask in Electrical technicians
