Answer Posted / kumar
1)I/P PROBLEM
2)INSTRUMENT AIR LEAK(Signal)
4)FLOW DISCHARGE FROM THE PUMP MAY FLUCTUATING.
| Is This Answer Correct ? | 15 Yes | 2 No |
Post New Answer View All Answers
Identification of control valve parts.
Valve positioner and actuators in detail.
what is diffrance between FF & SMART, explain with difination
Using your own examples solve a problem involving normal table. (experimental method and analysis)
What pressure results for a flow transmitter of range 0- 180t/h in the dcs and 0-301mbar in the field using square root extraction. Kindly also suggest formulae for the percentages 0,25,50,75,100?
What is wet leg condition and why is it used?
Calibration procedure for Electro magnetic Flow meter
Can any one tell me what type of question asked for instrumentation and control interview panel??? pls mail ramashankar.goel@gmail.com
why we should maintain neutral earth voltage below 1V while calibration? why cant it be 1.2V or 2V
What is the basic difference between Modbus and CAN Open Protocols
Any one can help me to identified, how can we interchange the device in FF
What is the formula of vabration sesore. i mean how to covert mils to volt plz share if any body knows very argent : my mai is merajalam143545@yahoo.com
what is the importance of CV in the control valves? how it is calculated?
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
Why flow/pressure transmitter before control valve?
