If any control valve create hunting problem, what is the
possible reason and solution?
Answer Posted / s.k.bakshi
1. First check the positioner air supply and the positioner.
2. If problem persists tune the PID.
Is This Answer Correct ? | 8 Yes | 7 No |
Post New Answer View All Answers
What are the uses of orifice plates?
what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?
Displace type LT to be calibrated in workshop, wt. 40, dia- 60 mm, density- 0.8kg/cm3.
Calibration procedure for electro magnetic flow meter
Name different parts of a pressure gauge. Explain the use of hair spring in the pressure gauge.
How does your previous experience relate to the job you are applying for ?
Explain PID, ON/OFF, Controls
why we use the ac supply load cell>?can we use the dc supply load cell?advantages and disadvantage of the ac supply load cell?
If relative y axis vibration sensor is by passed, and relative x axis and absolute sensor is left working. how much monitoring i would have risked?
Q- Control problem are mainly classified in _____ types. a-)4 b-)3 c-)6 d-)nono of these Few of them i know is 1- regulator type problem (eg- Air conditioner) 2- tracking problem (eg missile trcking problem) 3- sybernatics 4- optimal control problem
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
this site is owned by an nonsense
What are different types of orifice plates?
what is wave length were using ?
WHAT IS TMXT IN TEMPERATURE FOUNDATION FIELDBUS.