what is o2 analyzer and how it measured ,what is the role of
this analyzer in cfbc boiler...
- 2 Answers
- 11897 Views
- I also Faced
- E-Mail Answers
Answer Posted / madhava reddy
O2 analyzer is used in all types of boilers like CFBC and
AFBC etc..role of this analyzers to measure the O2
concentration after the ECONOMIZER ,it is a normal value like
(3 to 4) no problem ,if any variotions obeserved based on
that value we can increase/decrease SA fan air into the boiler
| Is This Answer Correct ? | 20 Yes | 1 No |
Post New Answer View All Answers
can any send me a forbes marshall dtron 316 manual
Q1]IF THE RANGE FOR FLOW IS -35 TO 125 WHAT WILL BE THE SPAN FOR ABSOLUTE AND FOR NORMAL? Q2]HOW TO CALIBRATE CAPILLARY TYPE LT? Q3]HOW MANY ERROR CALCULATIONS ARE THERE USED IN PROCESS INDUSTRIES? Q4]HOW TO CALIBRATE TEMPERATURE TRANSMITTER? Q5] HOW TO CALIBRATE LEVEL TROLL AND HOW TO CONNECT? Q6]PLEASE TELL ME THE BASIC FOR INSTRUMENTATION WHICH IS APPLIED FOR CALIBRATION AND FOR ALL? PLEASE MAIL THE ANSWER TO honest_yes@yahoo.in
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
why using negative supply for bentley nevada vibration system ?
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?
What are the materials available to prepare individually for competetive exams in Instrumentation field? Plz reply...
what is temperature compensation?
How will you calibrate an Absolute Pr.Transmitter of range 400mmHg absolute ?
What is critcal speed. what is resonant frequency. why we want to cross crtcal speed on higher RPM (early).
䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ
how to commission furnace ( water heater)
What is instrumentation instrumentation engineering?
Please can anybody help for control valve sizing step by step procedure?
what are the documents(Construction point of view for a process plant) submitted by contactor initially entering in to new site for client?
Why rdt and thermocouple both give different output .and one things more, how to generate ohm or mili volt plz mail me merajalam143545@yahoo.com
