Interested to Buy Any Domain ? << Click Here >> for more details...
wat is the optimum mix design for M25 grade of concrete ?
is the ratio 1:1.5:3.65 correct?
- 7 Answers
- 34720 Views
- ACC, I also Faced
- E-Mail Answers
Answer Posted / er shalu verma
OPTIMUM MIX DESIGN FOR M25- 1:1:2
SO 1:1.5:3.65 IS INCORRECT RATIO OF M25 MIX DESIGN.
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
I am a civil engineering student and going to attend interview in this week in an IT company.Will they ask me questions about my area of interest or cs
In foundation design, while we do the base pressure check, we normally check if the attained pressure value is less than the GROSS BEARING CAPACITY of the soil which is the sum of net bearing capacity of soil and the overburden pressure. Actually, the overburden pressure acts against the net bearing capacity of the soil and I feel that we are actually increasing the bearing capacity value and doing the check. I feel that this is NOT right. Please clarify on this.
How you can turn off the display for dimension in CAD?
The portion of a brick cut across the width is called?
pls tell me , what is the water content
Hollow block masonry in cement mortar 1:4, 40×20×20cms in superstructure take 10sqm.I want calculation of brick sand
For sloping slabs or sloping beams why the tension steel from either side of ridge is taken into compression zone of other side?
What is passive earth pressure ?
Define What is diversion tunnel in a dam?
02. a. The diagonal of a 9 cube…………… 1 b. Surface area of 9 cube…………… 1 c. Volume of 1-3 cube …………… 1 d. Compressive area of 6 cube …………… 1 e. Top & Bottom face of a Cylinder/Cube is to be proper leveled to deliver the…………………………..…… properly.
how can we construct building without foundation providing only grade beam at ground level
flow of fluid takes place viscosity compressibilityu surface tension deformation under shear force
how lap length is increased with increase of Grade of steel?
what is derating factor in cable? what does it mean if derating factor is high/low in terms of thermal resistivity of soil?
In the roof of a pumping station explain briefly the components of a waterproofing system?
