how we can save the power ?
suppose the electricity board gives 11 kw , but the
machine require only 8 kw means how we can save the exese energy
- 2 Answers
- 4208 Views
- I also Faced
- E-Mail Answers
Answer Posted / wareagle
That is not possible. You maybe saying that the EB is
providing 11 kva and you need 8 kw. If so, then the power
factor of the load is 8/11 = 0.72. You can add 7 kvar of
capacitors to improve the PF to 0.99 an you would reduce
the load to 8 kw.
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
HOW TO WORK A VFD?SAY SIMPLE METHOD
1)What is a Triode? What are its uses? 2) What is a Triac? 3) What is a Thyristor?
How phase displacement change in the over current relay coils.
What is the use of mc( moving coil) in dc voltmeter and dc ammter and what is the use of ( moving iron)in ac voltmeter nd ac ammeter
what is servo motor and how it works?
in our all power plant have connected in grid and grid voltage and plant voltage is same, but as per as electrical concept the power will transmit from high potential to low potential but here altough same,then how power transmit from power plant to grid.
how to calculate sizing of NGTR (Transformer rating,Loading resistor value and Current rating of resistor) and what is the X/R ratio. Details : 11kV,Capacitance 1.73532 micro farads,40kA for 1sec.
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
Hi everyone, I'm Lachuu, recently joined automation company as PLC Engineer. I have certain basic question, I request all big gurus and seniors to answer these question. Because this will be very helpful to me as well starters like me. How to design a control circuit (ex: pick & place - my current project) Yamaha robot PxYx series controller RCX222, using 6 cylinder double acting, plc keyence kv p16r 2 expansion unit for input and output each. How to select panel terminal mcb elcb powersupply. My main concern in some projects how to select dc power supply, mcb rcb(I came across dif bt b c d curves, but stil confusing, pls help me :-(. I would really appreciate all who are going respond to this question.
How we can come to know the substation range,without go through any name plate ?
what is x'mer ,isolation x'mer & yltra-isolation x'mer?????
What are the criteria shall be considers for sizing Fuse and MCB? If the rated current is 10Amps what should be the fuse size / MCB Size?
sir please send me iocl written test paper in my e-mail account. i'll be obliged to you........ thank u roshan
i had aplied Hindustan Petroleum corporation limited for the post of maintenance technician -Electrical,i want model questions,if anybody have please send it or please advice?
