What is the difference between MCB & MCCB,
Where it can be used,
- 22 Answers
- 136964 Views
- ACB Group, Badve, Bajaj Electricals, Hensel, Siemens, SR, I also Faced
- E-Mail Answers
Answer Posted / pakkaran
confusing . just go and see wikipedia, its there , or else
read CHESNEY BOOK . CLEARLYY U CAN SEE THAT K
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
Sir,In our company there are 3 caterpillar make(capacity:(1) 3.3KV,2.5MW(2)3.3KV,2.5MW & (3)3.3KV,1.9MW) & 1 deutz make (capacity:11KV,3.8MW)gas engines utilised,all are running in paralell. There are three transformer utilised,(1) 6.25MVA,3.3KV/22KV,Impedence voltage:6.7% used for two generator,both are 2.5MW(2)5.5MVA,3.3KV/22KV,Impedence voltage:7.2% used for one generator of 2.5MW & (3) 5.5MVA,11KV/22KV,Impedence voltage:7.8% used for one generator of 2.5MW.all generator breakers capacity of 1250Amps. Sir,I want the details of fault level calculation of generator,transformer individually & for whole system. If you require any information from me.feel free for contact me sir.pl.send the answer of my question as the earliest as possible.
Electromagnetic torque developed by the motor is compared to shaft torque. A less B same C depends on motor design D more
for a 500 KVA connected load, I calculated 30% of capactor for power correction. Even after using 225 KVR capactor PF is not improving. What could be reason for low Phase correction factor?
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
model question paper for supervisor trainee
which stabilizer is better ? AVR, Servo Stabilizer, Static stabilizer etc & why explain it
send me all basic electrical question and answers
What are :- AC Distribution Board (Single & Double Front) DC Distribution Boards Distribution Board LT Breaker Panel.
The slip during plugging operation is given by= A 1-s B 2+s C 1+s D 2-s
how to calculate differential current when we testing differential relay..suppose we have 1000kw generator,630amp VCB,what value we should put /inject so that relay trip the VCB? PLLZ justify ur comment
please give me all the Alarm .Trip ,Safety Relays & Conditions of Diesel-generators mail me on ashokbabunhce@gmail.com
can i connect wavetrap in 2 different phase in EHV line?
what is the significance of cabability curve of alternator
What are the material used for resistor?
hello friend i wish to study a course related to the electrical construction, controlling and monitoring , which course i want to study? pls give me the name of institute?
