Answer Posted / rushikesh s gaddpawar
CONTROL VALVE CALIBRATATION MANLY USE MA POWER SUPPLY
SOURSE TO CALIBRATE CONTROL VALVE
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how to calculate signal cable sizing? and multipair cable sizing??explain in brief?
How can we test a bently nevda 3500/42M accelerometer monitor card by simulating it with test equipment?. what king od of signal (milli volts or volts or or resistance ) we should feed in the terminals of the card?
Draw bode plot of any transfer function. Why is plotting bode necessary?
How does your previous experience relate to the job you are applying for ?
How would you choose differential range?
With N nodes and B branches what will have a network ???
How to Calibrate Vortex Flow transmitter in field
Why thermo wells are used? What materials are used in thermo wells?
what is installation and commissioning of (fat & sat) of power plant dcs ? this question keeps in desirable conditions of one company .
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
Q- Control problem are mainly classified in _____ types. a-)4 b-)3 c-)6 d-)nono of these Few of them i know is 1- regulator type problem (eg- Air conditioner) 2- tracking problem (eg missile trcking problem) 3- sybernatics 4- optimal control problem
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
What are continuances of connecting earthing and shield of branch cables (instrument to Junction box), at the same earthing pot provided on JB? Is it ok, or may produce some problem?
what is the difference between scaler and vector drive
Why flow/pressure transmitter before control valve?