Why should we use Star-Delta connection in step down power
transformers?
- 7 Answers
- 18589 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / rafeek
question is wrong,
normally we use delta-star connection for step down
transformer to prevent earth faults.
| Is This Answer Correct ? | 0 Yes | 4 No |
Post New Answer View All Answers
Why air circuit breaker off due to power failure?
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
how to calculate the conductor size for certain KV transmission line and distribution line?
is there any chart showing the suitable cable size according to AMP and length ? for three phase motors
why on delay timer used for fully automatic star delta starter?
What happens if we run alternator on under frequency?
what is effect of leading power facter on the system and billing
how to calculate percentage impedence at 75 deg C at normal tap
What are Contactors? How they works and what its highest rating?
hey guys i scored 910 on GRE and 67 on TOEFL respectively.I have an aggregate of about 74%in my B tech.For which colleges should i apply for an MS program in electrical engineering.I am looking for colleges in NJ,SC,NC,GEORGIA, NY. Please reply with a good response.....
cc of scorpio?
What is the form name of 'c' license, I want to download in web
what is the difference between electrical choke and electronic choke?
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
How convergengr of nr method is not dependent on selection of slack bus and how gauss siedel method depends?
