Interested to Buy Any Domain ? << Click Here >> for more details...
can we replace a pressure transmitter of range 0 to 25
Kg/cm2 by a Pressure transmitter of range 0 to 10
Kg/cm2 ?.. Will it affect 4 to 20 mA output signal which we
will feed to the PLC.
- 9 Answers
- 13715 Views
- IOCL, I also Faced
- E-Mail Answers
Answer Posted / ruchita
Yes it will affect the 4-20 mA signal. say for example if we are using PT of rsnge 0 to 25 bar bt internally we use only 0 to 10 bar range den it can be replaced otherwise not
| Is This Answer Correct ? | 9 Yes | 4 No |
Post New Answer View All Answers
What is instrumentation instrumentation engineering?
How many types of sensor
How to Calibrate Vortex Flow transmitter in field
What is stripper & spilitter ? Diffrence in this.?
if in a level tx height is given, how u calculate the ranges of the tx?
give me the formula for analog to digital converter and also d to a converter
what is the procedure of O2 sensor(ABB) calibration?
how u choose thermowell lenght n pnumatic C/v size?
HOW TO CHOOSE FREAQUENCY IN FMCW TYPE RADAR INSTRUMENTS. DESIGN BASIS OR DESIGN CALCULATONS ?
model question paper of instrumentation for Jindal GET 2010.plz reply sudhanshukumar08@yahoo.com
Explain the burnout feature.
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....
What is sensitivity in vibration probes..?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
