how much kn lightning arrestor is used in 11kv line
- 8 Answers
- 12922 Views
- Power Grid, I also Faced
- E-Mail Answers
Answer Posted / vysakh
11 kv LA must be used for 11kv feeders.It act as a near insulator till the break down voltage & act as a conductor there after.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
best manufacturer for busbar for outdoor switchyard having double bus bar scheme, can any one share technical specification of busbar. 132kv voltage ?
What are the different types of LT Cables?
What are the advantages of autotransformer?
HOW WORK HEAT PLATE EXCHANGER
Determine a suitable number of slors and conductors per slot for the starter 1 winding of a 3 phase, 3300 V. SO Hz 300 rpm alternator. The diameter is 2.3 m
Transformer cores are laminated in order to A simplify its construction B minimize eddy current loss C reduce cost D reduce hysterisis loss
for compensate 315mh inductance ,how many capaciance required?
What are the difference between normal application Transformer and Solar application Transformer?
what are problems caused by the pdu in rack server
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
what is the use of surge suppresser in 33 KV incoming panel. where it must be installed,inseries with incoming cable surge suppresser must be at incoming of the breaker are outgoing of the breaker
physical identification of HT & LT panel
what is draiv work
what is the id1 & id2 setting in differential protection relay of CSPC?
if the number of poles generated in stator and rotor side of an induction motor are different then what will happen and why?
