Where the ON LOAD TAP CHANGER is provided in the setp up
transformer?
- 2 Answers
- 3984 Views
- I also Faced
- E-Mail Answers
Answer Posted / a.muthukumar
Always ON LOAD TAP changer is provied in HV side only.
Because HV side current is low and LV side current is high.
So, during on load tap changing losses will be reduced when
on load tap changer is in HV side.
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
PLEASE SEND THE PREVIOUS YEARS QUESTION PAPERS OF RRB JUNIOR ENGINEER-ELECTRICAL
While testing a ZCT what parameters have to check or measure?
How can we calculate the motor frame sizes?
My question is abt backlog.I had dropped one subject in my second year, and completed this subject in the 3rd attempt, so how many backlogs i have got?1 or 3?plz sujjest the answer as soon as possible
i m electrical diploma holder i want to do plc $ Scada some body tell me which insitute is best for me near chandigarh
why booster transformer is used in sumpners test conducted on transformer????
What is the difference between cylindrical-type and sandwich-type winding?
why ahould you show client/engineer activities clearly on the project plan
WHAT IS DIFFERENCE BETWEEN MANUAL CONTROL AND MAGNETIC CONTROL AND STATE ITS ADVANTAGE /DISADVANTAGE
what is the mechanical safety of DG ?
if we give 60 hz single phase supply to the transformer used in europe , than what will happen
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
what is difference between speed mode and torque mode in motor?? explain in simple words please.
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
If we need 4c× 50mm sq cable but it's not available so we can pull 4c×25mm sq two cables?
