why normally Generator rating are between 11Kv to 22Kv?
- 7 Answers
- 16465 Views
- Torrent Power, I also Faced
- E-Mail Answers
Answer Posted / ashok kumar gupta
ONE REASON IS GENERATOR CURRENT AND 22 KV CAN BE FED DIRECTLY TO THE LOAD FOR SMALL POWER REQUIREMENTS AND REDUCTION TO DISTRIBUTION TRANSFORMERS OF 11 KV WILL IMPROVE EFFICIENCY.
| Is This Answer Correct ? | 3 Yes | 5 No |
Post New Answer View All Answers
State magnitude criterion.
what is mean by NPS (Negative phase sequence)fault? what is the difference between EFR & OCR faults?
nwhat are the main Components of servo motor?
why we use copper earthing for neutral while for body GI.
if two transformers are placed parallel & both have fault impedance of 50KA will it increase or decrease show example?
How we calculate DC inducation moter Amp? Sir pls give me formula......
Is Transol transformer oil comparable to nynas nytro libra?
Explain the difference between verilog task and verilog function?
If I have Energy Meter Ratio as 100:5 & Also I have CT Ratio as 50:5 then what will be my multiplying Factor(M.F.)
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
State thevenintheorem?
how slip power recovery system work
how to failure indution motor insulation & how to improve heat in motor insulation
What would be the size of wire used for 2 Ton of window A.C?
What is given by the definition in BIL IMP/PF = 950/395 kV. This was found in a name plate of a power transformer.
