control valve in manual/auto mode huntting checked spring
tention also it is ok.positioner also good condition &
incoming inst air line also constant pr.kindly give us
correct answer?
Answer Posted / gopalakrishnan.p
Kindly check the following thigs for betterment
1.Loop tune ur controller.(gain value,integral
time,derivative time).
2.Check the cable(connector side ..i,e may be loose
connection).
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
how to work static pressure sensore how to work dpt
when a magnet is heated?
What is the differerence between hysterisis and linearity.
Explain plc level and its type?
all questions related to instrument technician in any offshore oil and gas company.
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
Specific gravity.
Why is the orifice tab provided?
How to Calibrate Level Troll in field
What is the difference between modbus,fieldbus & profibus
A flange is used for instrument connection for a system with a design temperature of 316C (600F) and a design pressure of 1000 kPa (145 psi). What is the class rating of the flange to be used for this application? Explain your answer
if my flow is 20000 m3/h than which range of DPT i have to use????
A valve in series with an orifice plate (DP transmitter), is aligned for constant pressure in the pipeline, if there is an error dx, How to align it in process.
what is sil (safety integrity level
why fuse block is not used for AI signal?