Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between gypsum and pop?
- 7 Answers
- 51747 Views
- ncrt, I also Faced
- E-Mail Answers
Answer Posted / karan sardana
gypsum boards are used for false ceiling purposes bcoz of their inertness towards water in case of leakage, while pop is used over plaster to cover the irregularities in plaster....it also smoothens the plastered surface...
| Is This Answer Correct ? | 24 Yes | 16 No |
Post New Answer View All Answers
Iwant to calculate the production of 1 labour for concrete casting which includes shuttering,scaffolding,steel fixing,concreting, deshuttering and curing in 8hours.But i am not able to determine it approximately would you pls.??
What is the usage of zoom command?
How much area will be covered in 1 litre of Velvet touch paint in normal wall condition
How to find out slope footing concrete
What is meant by autocad?
How much cement is require in one sqft area in a G+3 residential construction.
which are the Indian auther books for STONE COLUMN/GRANULAR PILES?
how can we calculate steel value, depending on load
Suggest how many column, beem, etc required for 30 mtrs x 21 mtrs width x 8mtrs height for industrial shed of ground floor. I want to know the quantity of tmt steel consumption and Concrete consumption for budgeting
For the symmetrical continuous beam shown in figure, Prestressed with a force P = 1500 KN along parabolic curve as shown, compute the extreme fiber stresses over the central support for the uniformly distributed load of 24 kn/m. Use load balancing method.
Suppose you planning to paint newly fabricated workshop building made of structural steel of 10 tons total mass. How many litters paint primer for 1 coat and 2 coat of top coat?
1.Fe500 and Fe550 having more yield strength than Fe415.But why are we prefering Fe415.? 2. d^2/162 formula for knowing the steel wt/m apply all these three? Thanks.
B.M DIAGRAMS & S.F DIAGRAMS OF CONTINOUS BEAMS
can we make bricks using m10 grade cement concrete and what would be the ratio of raw materials used and price per brick ?
Design a cantilever type retaining wall to retain sand for 4m above the ground. The sand fall slopes at the rate of 1 vertical to 2 horizontal. The weight of sand is 18000 N/m3, the angle of repose being 30. The safe bearing capacity of the soil is 200 kn/m2 at 1/25m below the ground level. Use m 15 concrete mix.
