in transformers for ex. 100mva and 400kv the secondary
current is about 420 amps but for selection of bushing the
capacity of selected bushing is 2000A why there is such
big difference ?
- 2 Answers
- 4035 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
The insulated leads of secondary from the Tr windings are
taken through hollow rods inside the bushing and connected
at the top.As the rod has to bear the all the mechanical
forces like torsion and strain, the wall has to be thick enough.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
There is any especial requirement for motor to drive through with VFD?
define the active power?
Can you please explain creepage distance in detail, for a 6.6kV cable head what must the distance be and how do you determine it?
What is the meaning of dedicated earthing?
how does a shunt reactor maintains the bus voltage???
what's the difference between abs/inc encoders. apart from the position remembrance what are all the other differences. and what's mean by grey code.
Single phase and threephase power calculation
i need some project topics along with circuit diagram in the electrical adnd electronics engg and also give ome website regarding projects.my mail id is thenmozhi2k7@gmail.com .please help me.
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
Why it is necessary to isolate fire fighting when you are taking shutdown for lv board.
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
Transformer diagram mention each parts ?
What is process of anneling transformer core
How RTCC panel is working and give single line diagram for RTCC with transformer?
what should be the ideal gauge of wire (In sq mm) for different loads in Ampere?
