avr is an automayic voltage regulator ... it regulates
voltage before it synchronise with grid after
synchronisation it regulates power factor why....
- 7 Answers
- 6916 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
AVR maintains the set voltage and does not regulate it.APF
mode is an option in Auto- channel in addition to AVR mode
and it is put in action after synchronization.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What are the site acceptance tests for power cables, DG Sets, LT panels & 30kVA UPS ?
what shall be no load voltage of 132/33 kV transformer ? is it 33 kv of 34.5 kV
What is the control action?
it is in our knowledge tht right plug of supply of residential suppy system is phase n other is neutral...howevr the battery charger of mobile works in both ways...i mean it is not restricted in only one direction.ny of the holder of charger can hav phase .so y is it not lik tht phase of supply must b connected 2 phase of charger...?
How many types of circuit loads are there in a common electrical circuit?
How can we connect additional batteries to three phase ups? What are parameters we have to check when connecting?
How you calculate the repturing capacity of a HRC fuse
if grounding is notdone at regular intervals for long distance transmission, will the load connected at distribution end receive voltage during negativehalf cycle of the sine wave?
I have 2 KW electric water heater.I am gonna use it in controlling water temp.so I needed to increase or decrease the heating capacity.is there any electrical-electronic circuit for varying the resistance & so current?
1. for eg, capacitor is used for many purposes(it act as filter, oscillator, bypass capacitor, memory storage etc...) 2. Please tell me some example circuits for different uses of capacitor( whenever and whereever and however we used capacitor as a filter, oscillator tuning etc..) 3. similarly for inductor and resistors(it act as what?) and when and how we want to act as like that?, and how we can used these components depends upon our requirments with example circuits and explanation? design to act as these components depends
Starting Time of LT & HT Motor
During FEED, you will have all the information with regards to cable. How will you calculate the MTO for MV and LV Cables? what are your considerations?
How we select the vector group of 3phase power transformer?
write down the formula of cable size in RM if current is 50Amp.
should %impedance be high or low in a power transformer? if so why?
