Interested to Buy Any Domain ? << Click Here >> for more details...
Is it necessary to place tap changer in secondary winding or
we can use on both sides?
- 3 Answers
- 6150 Views
- I also Faced
- E-Mail Answers
Answer Posted / dffg
As i know it is used at the hc side of the
tranformer.Becouse there are more windings on that side and
so it is easier to make a regulation.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
DG cranking voltage?
Define piezo-electric effect?
to hook up ten 50 amp rv pedastels at a lenth of 600 feet from the service what size will my service need to be and the size of wire will I have to run to each pedastel in series??????
WHAT IS THE FORMULA FOR CALCULATING CURRENT RATING(DIRECT IN GROUND OR AIR) OF ARMOURED(XLPE) CABLE OF 4C,16Sqmm?
if i get a drop in my 1st year and the i clear my 2nd year and 3rd year all clear and i dont have any back logs so can i be able to sit in campus selection??
What is the formula to calculate the rating of a three phase miniature circuit breaker
What will be the output voltage of a transformer if it is primarily energized from a square wave voltage source?
what are the installation procedure of high voltage power transformer,CT,CB&PT?
IF alternator SCR value will be high means what happen in alternator efficency at operating power factor of 0.8
When calculating the speed of a rotor required for a particular frequency of synchronous generator we use the equation 60f/p Is this p is the number of pole pairs of rotor & do we consider the number of pole pairs in the stator is 1?
Name one of major transformer company in KSA ?
does the Trivector Meter of three phase automatically takes care of the low power factor and gives the reading accordigly or it does not take care of the Power factor while giving the readings please explain
Direction of flow of active power and reactive power with logic?
List out the the types of Mounting Light fixture?
Haw to check conductivity of budbar
