Interested to Buy Any Domain ? << Click Here >> for more details...
What is the method of Tan delta test for power Transformes
and why it is required.
- 1 Answers
- 5803 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
The dissipation factor (tan delta) represents the gross
defects and overall dielectric losses in insulation.For this
an instrument(HV transformer ratio arm bridge) is available
for measurement of tan delta and capacitance.To assess the
state and quality of the mass of tr insulation ,the
following test schemes are used during measurement of tan
delta.1.HV vs LV grounded to tank 2.LV vs HV grounded to
tank 3.HV vs LV ungrounded 4.Bushing insulation with respect
to test tap.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
compare between starting charactristics of synchronous motor with those of 3Q Squirrel cage induction motor
how calculate the electrical load for industry and office
what is difference between speed mode and torque mode in motor?? explain in simple words please.
What is meant by time harmonics and space harmonics?
what is the concept of directional power?
What types of CMOS memories have you designed? What were their size? Speed? Configuration Process technology?
How will you justify IR value and Charging voltage of any motor,transformer and Cables.......???? . . . . . . . . Plz tell me any body Baljeet Singh, engineer_89@refiff.com
Does outdoor isolator loose connection cause short circuit current in that circuit? if yes then how ??
what is difference between elr and R eartl realy.
Hello sir, pls send me hpcl technical test papers .i am. Appearing for the exam.
why i can not use thimble on capacitor duty contactor
What is the difference between indoor and outdoor transformer
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT-SWITCH BOARD,MLDB,ACB,BUSBAR,ETC,......?
how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .
In between UPS out going changer over switch and ups raising main input, both side cable gland producing heat but the cable doesn't get heat,Why?
