What is the method of Tan delta test for power Transformes
and why it is required.
Answer / k.prakashchandra
The dissipation factor (tan delta) represents the gross
defects and overall dielectric losses in insulation.For this
an instrument(HV transformer ratio arm bridge) is available
for measurement of tan delta and capacitance.To assess the
state and quality of the mass of tr insulation ,the
following test schemes are used during measurement of tan
delta.1.HV vs LV grounded to tank 2.LV vs HV grounded to
tank 3.HV vs LV ungrounded 4.Bushing insulation with respect
to test tap.
Is This Answer Correct ? | 1 Yes | 0 No |
66kv under ground cable how to layaing in ground any special case two ckt r runing
hi i will D.E.E.E.is completed pls send rrb diploma old qustion papaer sent in my e mail. i.d.
(1)Electrical power is generated in KV, power consunmed is in MW and the transformers used are in KVA. How is KVA converted to MW as power being consumed by the consumers? (2)What is vector group of a transformer?
1))why we run three phase or three different circuit from a single conduit 2)) why not two circuit of different phase run in same conduit?? and why we run same three cicuit of same phae run in single conduit??
what is load flow?
what is the change over switch ,switch disconnector ,bypass switch and switch disconnector fuse unit?
why tertiary winding is used in transformer with diagram?
What type of wiring series or parallel is used for conventional and addressable type FAS & why?
What is application of isolation transformer & How it works.
Operation carried out in thermal power stations?
What is the maximum size(MVA)of power transformer available in the India/world?
Pure inductive ckt takes power from AC when 1. Applied voltage and Current increases 2. applied voltage and current decreses 3. voltage decreases and current decreases please justify