why neutral wire thin than phase wire in 4pole conductor
- 5 Answers
- 12550 Views
- Hero Honda, I also Faced
- E-Mail Answers
Answer Posted / preethi
please sir can u explain once again clearly and another doubt
if any abnormal conditions in phases neutral grounded is essentially needed?
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
what are the 4 rules to start the motor?
how to find out 3 phase complex power in per unit in unbalanced system?
can anyone give an idea about dia calculation in cold rolling mill
If one tertiary phase i.e. R,Y or B is earthed of a loaded type tertiary delta connected (Without load)of a power auto transformer, what is its advantage/disadvantage?
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
what is the transformer rush current?
State magnitude criterion.
what id a dry type transformers and its function ?
control & auxilary circuits used for circuir breakers
state types of reflectors in illumination engg. ???????
what is level 2 automation?
Does magnetomonopoles exists? one maxwell equation strongly suggests no, but how about their existance in plasma?
Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
How is the gain affected by the introduction of feedback in a control system.
