Answer Posted / ravinder kashyap
work of a starter is reducing high starting current
in star connection voltage is Vph=Vl/root 3
so at starting time of motor we are use star connection at
starting star connection are use then after picking normal
speed after this delta connection are applied to motor
this is the principle that by use of star /delta voltage
conversion scheme
Is This Answer Correct ? | 25 Yes | 5 No |
Post New Answer View All Answers
what is lumped and distributed elements?
In a carnot engine with an efficiency of 40%, the heat rejected to the sink at 27 C is 60 kJ, then the heat supplied in kJ to the engine by the sources is
I completed my BE EEE degree 2006 .... which license should i apply .... ?????
A cotter joint is generally used to transmit
What is the general system requirement of alternator?
bsnl tta exam question
what is cascade speed control device?and how this device control the speed of motors?
what are the precuation should be taken ahen installing power transformer,circuit breaker,current & potential transformer
Why the arms of delta in a delta-wye power transmission system are kept constant??
why does rotor rotets?
What is contract demand in solar system?
11 kg trivevter meter has rating of -/5amps. And pt ratio11000/110v and is connected with 11kv ct/pt unit of cr ratio 75/5amps. And pt ratio of 11000/110v while checking accuracy of meter with HT Accuchek meter what value of PT ratio and CT ratio to be filled in Accuchek meter
How much load can take a 16 mm aluminum cable 3 phase
Both generator parallel condition shared load equally but one genrator taking ampere more than the other what are all the causes to make like this
Any one can explaination about calibration with rotating sub standards?