what is the effect if we add capacitor on DG supply, it has
any loss or benefit.
- 6 Answers
- 11256 Views
- I also Faced
- E-Mail Answers
Answer Posted / venkatasubramanian
capacitors are used for produce the inductive power, so that
we can reduce the active power. i.e, genset producing
current is low. Normally when the motor ON some magnetic
field is also produced That magnetic field consume more
current, when we use the capacitor in parallel with the
circuit. It is Balanced.
so capacitor used .9 to .95 (lead/lag) to reduce the
load(producing current) to save the fuel.
By Venkatasubramanian (VVS)
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
if a number of plc s are there then how many modbus to be used
How to calculate the External Resistance required for 60HP slipring motor in case no any data of the Motor is available???
why steady state stability limit is greater than transient stability limit ? How it can be explained ?
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
what is earth fault relay 64T, why it is used in main Incomer and neutral CT of Transformer.
Can any body tell me about INNER SHUNT COMPOUND MOTOR diagram?
How to decide cable tray size?
Is it possible to make a 5P10/ CT Ratio 50/1A Burden 5VA
Why the arms of delta in a delta-wye power transmission system are kept constant??
Can 4pole (3 phase+neautral )RCCB proper functioning in only 3 phase load (no neautral, no Earth) ?
why should small green grass ans small plant should not be there inside the transformer Yard in the factories
single phase power supply give to separate one steel coup with water, what reaction create
what are your career plans upon completion of the programme and the relevance of recity generation to your professional development?
How to minimize the eddy current losses?
what is negative and zero impedance in 3 phase induction motor ??
