There is 3phase power cable from 1 point to the other point
which is 100m away. Two point equipped with power meter and
recorded 1st point is 205kW while the 2nd is 202kW and each
phase average carry 400amps. To calculate the resistance of
the 3phase power cable, is the formula using will be P=I2R?
Answer Posted / k.prakashchandra
Yes
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
what is transient stability analysis means?
How to calculate LT XLPE CABLE for 11 kv / 433 v , 1000 kva oil type transformer system?
how to measure the current by compact digital equipment with dislay which fit inside any equipment
what is the meaning of osr in transformer.
how electrical earthing maintenance done in industry?
what is the standard values(Megger test) of resistances between L&N,L&E and N&E for a system on IEE regulations?
plz send me the procedure and syllabus for mseb exam
I am apply the AAI. So i want electrical sample question paper in technical with answer my id is vijayjobsmart@gmail.com
Define the term factor of inertia.
what is the difference between ups & inverter
in control scheme dc logic wiring commonly using negative loop,what is the reason?if we use positive looping what will happen?
Why do we mostly prefer to generate and distribute electricity in 3 phase and not in 4 phase or 5 phase?
State uses of different types of stsrters with different capacities of motors as below: a. up to 5HP b. above 5hp to 10hp c. above 10hp to 20hp d. above 20hp
how many types of motor can be used in washing machine