Why slip-ring and brushes are not required in squirrel cage
induction motor?
- 4 Answers
- 8886 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / mohamed idris
slip and brushes are not used in squrriel cage induction...
bec rotor windings are look like a cage... therefore
windings are short circuted by end ring.... therfore no need
to use slip and brushes in squrriel cage motor
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what is difference between 2 pole structure and 4 pole structure in transformer yard
power transmission pole used one support , that only for support or earthing
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
i applied for c licence with my one year apperents trainee and i have attaced with A grade contractor company experiance that is for 14 monts experiance this document is sufeicant for c licence? pls tell why they rejected
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
what is the effect of connecting three phase supply lines to three phase auto transformer output terminals through a fuse of 10Amp and a circuit breaker (MCB). Is this connection permanently destroy the transformer?
The electromagnetic torque developed is proportional to what in a D.C series motor?
is it possible for different brand of H.V transformers to run or operate in parallel to each other? if so how much disturbance can this affact the H.V bus bar?
What is difference between Sample test and Routine test in safety standard?
State kirchoff voltage law?
How do we calculate the Out put voltage of generator, after the excitation is being given?
how circuit breaker work.. what is the operations taking place inside a circuit breaker when an overcurrent occurs... is it similar to fuse?
please tell me when we start motor without load in star or delta connection whose current above condition,pl write formula
what is the use of expulsition protective gap in 11Kv line.
What is the purpose of using busbar mounting fuse?
