what is meant by Is limiter?what is the use of current
limiters in electrical ditribution network?
- 2 Answers
- 6261 Views
- I also Faced
- E-Mail Answers
Answer Posted / shibu joseph
Is-limiter is a device for limiting the short circuit. This is a fast acting device and interrupts the short circuit typically in less than 3 m sec. This protects the other circuit breakers in the network with lower short circuit breaking current capability
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
what is the setting of locked rotor in HT motor ? (answer expecting in percentage)
Can u tell me design of switch yard
what is the criteria for selection of conductor used for ehv ac electrical dischrge
why different series of vfds (like allenbradley)are used in industry ?
Phase control and integral control are used for?
1.why are not using acb 33kv ht side? is there any problem 2.what is difference between acb,vcb,sf6 breackers? 3.what is the function of invertor and convertor in ups?
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
How to do cable earhing? whether by grounding Armour to ground or by running extra G.I wire along with cable? which one is preferred mostly amoung them? If the second one is more preferable how many GI wires to be run along with cable (1 or 2)?
Two liquids hot and cold in two vessels are there and an metal bar acts as a conductor of heat between the two vessels. what happens then. what happens after 24 hrs?
What is The Resistance Formula
mostly the questions were from machines... d.c. machines, transformer, synchronous and induction all theory paper........ few from power system... but the level of paper was easy.....
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
what are the different sizes of U.G. cable & where these cabl;es are used according to voltage ..
What are the advantages of thermal power plant?
What is stacking factor? What is its approximate value?
