To attain a powerfactor more than .95, how much kvr should
we use for 100 HP of current
Answer Posted / k.prakashchandra
Depends on the present pf, however 30 KVAR is generally
recommended.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
What is lifting power for 1 wb/m2 and 1 A magnet?
How Can You Relate Power Engineering With Electrical Engineering?
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?
How to calculate or formula to calculate rhe power in 2 phase system ??
Installation resistance for whole installation of 16 kva & 25 KVA DTRA a) Between each conductor b) between conductor to earth c) installation resistance for each apparatus, each conductor to earth d) earth resistance for the system of earthing
In ht capacitor ckt we are using LBS Panel it having isolator with fuse, one of HT fuse flash over, so what is reason behind this event.
From past few months I am getting lagging pf even though sufficient capacitors used in circuit. Where is the problem pls answer
Sir, plz tell me how droop setting is done in parellel operation od DG set ? please give practical example ?
How DC earth leakage currents can be reduced ?
why ten delta testing is carried out on power transformer
Explain few advantages of electric traction system?
What technology is used in latest generators?
How to design inductive load for 3 phase 440v and maximum 5 amps for star or delta? Can we use a 15kW, 1450rpm motor for 15kW, 960rpm apllication?If yes.how......n.if thesame motor used what`s it`s sideeefect.
Whata are the types of Cables?