Interested to Buy Any Domain ? << Click Here >> for more details...
if we supply DC power to AC transformer then what its result?
- 15 Answers
- 17782 Views
- I also Faced
- E-Mail Answers
Answer Posted / pillay
i appreciate mr william lobos concern and timely advice but
this is a question for one to think and make a analytical
answer which is correct for the answerer but may be wrong also.
the transformer will act as an inductor, it will burn out or
not depends on the transformers design and voltage applied
across. there will be no voltages induced in the secondary
because there is no change in flux other than when you "on"
& "off" it.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
can any one suggest me the tilt angle of my solar pannel ?? or tell me how can i know the fix tilt angle of my solar pannel?? my cordinates are 31.503629,72.993164.
i need project topics along with circuit diagram in the electrical and electronics engg and also some websites regarding projets.
What is transister define the transister ammiter ,base, colector.
it is in our knowledge tht right plug of supply of residential suppy system is phase n other is neutral...howevr the battery charger of mobile works in both ways...i mean it is not restricted in only one direction.ny of the holder of charger can hav phase .so y is it not lik tht phase of supply must b connected 2 phase of charger...?
1. What is maximum permissible distance between smoke detectors ? 2. How do we decide number of smoke detectors required in a large office, warehouse, hall etc ? 3. What should be maximum height of smoke detectors ? 4. Where do we use heat detector, optical smoke detector, temperature sensitive detector ?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What are the material used for resistor?
Assuming that a dedicated neutral earthing transformer is provided for each GT generator, when the two generators are running in parallel, has consideration been given that the earth fault current from one generator stator winding be split between the two neutral earthing transformers? If so, what adverse impact will this have on the operation of the 59N and 27TN devices?
please send me previose rrb junior engineer qustion papers
hi friends this is a newcomer in your community of enthusiastic peoples. i am preparing for SSC (CPWD JUNIOE ENGG EXAM FOR ELECTRICAL) pls guide me on the same how to crack it? PLS LET ME KNOW IS ANYONE THERE WHO PASED IT? CAN I GET THE QUESTION PAPERS OF PREVIOUS EXAMINATIONS?
what is the relationship between current&voltage in practical purpose ?
What is the unit of charge and current?
As an electrical engineer what are the responsibilities which i can hold in TCS?
why we use circuit breakers for switching instead of normal switching device?
Type of motor stater detail and working detail
