Answer Posted / nirmalyabasu
this signal is globaly accepted as a transmitable pneumatic
signal so for every pneumatic works this signal is accepted
or used.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
What is the use of control cable?
I m appointed as an automation trainee engineer in small firm in that I am only the one , my company give me a project on s7-200 as i m beginner I don't know how to program so please send me the helpful site so that I complete my project before deadline....please help me out in this critical situation.
what is zero and span ?
How addressable fire systems work? Pl. send details with architect.(Loop), also send details regarding Gas system. Pl. help me.Thanks
Name different types of bourdon tubes.
field bus transmitter calibration procedure tell me
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Explain operation of Haskel pump.
What is mean by analytical instrumentation?
what is the difference between -24 : +24 & 0:24 and where it use?
Can any one tell me what type of question asked for instrumentation and control interview panel??? pls mail ramashankar.goel@gmail.com
what can of fault ofently come in vibration mesurement?
What is ultrasonic flowmeter?
What is difference between radial vibration and axial vibration explain in detail .
what effects a surging can produce in the compressor
