Answer Posted / krupa s
clipper is the circuit it removes the unwanted portion of
the waveform (voltage)
clamper shifts the Signal(voltage) to the required level
Both are electronic circuits.
Is This Answer Correct ? | 23 Yes | 1 No |
Post New Answer View All Answers
What would be the size of wire used for 2 Ton of window A.C?
Describe Non I.S. Earth System and why is it used?
For an induction motor wat is the loading/unloading cycle duration or interms of L/UL ratio/ percentage?
what is static frequency converter?what is the function...of sfc...?
what is tri state logic gate
what is meant by k-rating in isolation transformer?what is k9, k14 stands for?
how we do Vector group ,magnetic balance and tap changer test in Transformer?
What is the purpose of stablization resistor in high impedance bus bar protection
If only R Phase is connected in 2 pole elcb, n is not connected than it will work or not in ground fault.
Capacitor is load free component but why ampere meter shows current when capacitor bank breaker close?
What is DC series motor?
What is load boxes ?
Difference between on line capacitor and Station type capacitor
what would u consider to be the basic purchase order information you would need to proceed with a cable inspection assignment?
physical identification of HT & LT panel