Answer Posted / gaurav khanduja

we will not have to connect the capacitor with the D.G.
because D.G. work on the principle of AVR(Automatic voltage
regulator)and AVR work always lagging PF. if we connect the
capacitor then it gives leading P.F.And O/P voltage of D.G.
will be vary so we never connect the Capacitor with the D.G.

What is the practical way to calculate the cable size for known ampere load?

945

---

What is load boxes ?

1598

---

I want formula to calculate current loss with distance in km.I searched many sites but didn't right answer.Plz reply me

1563

---

In how we connect watt meter for open & short circuit test of a single phase transformer.

5650

---

what is meant by neutral compensation factor and where it is used

1455

---

---

Hi, Next week Iam appearing RRB exam for section engineer. So help me to get modal question papers for this position. Iam very thankful to you. Whether question will be fully techanical format or general form. Please give me a details regarding this exam.

1470

---

WHY RATING OF VCB NOT LESS THAN 630A

2047

---

Hello Guys !! i want to rrb section engineer electrical(signal) previous model papers? any body help me?

1431

---

i want to know about torque of slip ring induction motor

1705

---

I have iti elec, 1st aid, and 5 yrs experience in 7.5 mw power plant. Am i eligeble for 11kv license in telangana state..when, how to apply for that.?

1852

---

How to calculate earth wire load by formula

1970

---

while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends

2374

---

what are the interview question asked in wind mill about electrical

1927

---

What is dynamo function in DG sets and draw block diagram?

1591

---

Good morning: I'm looking for some informations about the OLTC or the LTC: I wont to know what the function of the tie-resistor in during the operation of reversing/coarse operation Cordially

1571

---