why normally Generator rating are between 11Kv to 22Kv?
- 7 Answers
- 16455 Views
- Torrent Power, I also Faced
- E-Mail Answers
Answer Posted / vinod singh
now a days power is generated by using powerformers in some
contries at higher voltage. in england on lule river power
is generated at 30KV . and ABB is also planning to
manufacture powerformer to generate powerat 45KV.
morover power is generated at 26KV in mundra by tatapower
| Is This Answer Correct ? | 7 Yes | 4 No |
Post New Answer View All Answers
what is difference between window type and wound type transformers?where we will use window type and wound type transformers?
How many types of protection relays are there based on the characteristic?
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
how load of a turbo generator can be increased
how to calculate the earth fault current
can a 150 kva 3 phase 440v/230V delta-wye step down transformer can be use as step up transfoermer with connected loads at 440v side?
Give details on how you intend to handle a challenging position you are posted to manage unexpectedly as a company staff?
What is excitation in case of dc motor?
State thevenintheorem?
What are the three types of compensators?
why constant voltage transformer should be start without load? and if started then what will happen?
I want to know the 'Test voltage' for Tandelta testing of 3.3 / 6.6 / 11 KV Motors. Please explain
how we test a 3 phase motor on single phase supply....? HOW WE RUN A 3 PHASE MOTOR ON SNIGLE PHASE. supply for testing..? how we verify of a 3 phase motors 6 wire & name thame a1/a2/a3..b1/b2/b3 and c1/c2/c3 for connecting star delta starter ........i have only 1 phase supply ? help forum..........
What is the effect on in Zone and out zone fault if Phase side CT is Vk/2<30 mA and Neutral side is CT is Vk/4<30 mA for Transformer REF protection
What is the meaning of utility ground and clean ground? How the distribution panel is grounded?
