Using 11000V/433V,3 ph,50Hz,500 KVA, what is the maximum
capacity of motor in KW that can be connected and started at
a single moment? Also explain about any calculations and
formulas used in deriving the same.
Answer Posted / vijay krishna rao
considering DOL type of starter (so starting time will be
appx 6 times the rated current)and also considering starting
time of motor may affect the Xmer, then 500/6=83.33 MVA.
Motor rating (pf=0.8)=83.33*0.8=66.66kW (efficiency=100%)
If soft starter is used then motor rating can go upto Xmer
rating.
Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
WHAT IS THE MEANING OF BALANCED / UNBALANCED IN STABILIZER TYPES.
how can motor both beasrings insulation resistance can be check?
What is meant by reset level of the relay?
how generator load test is conducted?what are the steps?
hi, i have 3x200KVA and 2 x 80KVA UPS with battery bank of 150AH 68Nos. and 100AH 204Nos., i need to install AC either ductable or PAC type, so can you help me to calculate heat load and capacity of the AC to install.
Why neutral cable carry current.
What is the rating of a circuit breaker needed for 300 kv load in 33KV supply line of 33/415 transformer ? Whether 800/1200 amp vaccum circuit breaker can perform for a 33 KV line in input in 415 volt in output of the transformer ?
what is the principle of operation of tungstun bulb ??
-What should be minimum value of insulation resistance and maximum value of earth resistance at any electrical instillation and what is method of testing the same.
what is the use of current transformer in power transformer secondary side.?its connectyed in WTI
We normally make oil soak pits under Transformers. Oil from soak pit goes to collection pit. We provide granules/pebbles under transformers. My question is weather granules/ pebbles to be filled in soak pit or not? if yes upto what level?
How to resolve if Diesel generator stop while running ?
sir i have a car stereo system and there is jack on him so can u tell me a way to find out their power terminals on the jack or on the circuit board"
What is dielectric loss?
it is in our knowledge tht right plug of supply of residential suppy system is phase n other is neutral...howevr the battery charger of mobile works in both ways...i mean it is not restricted in only one direction.ny of the holder of charger can hav phase .so y is it not lik tht phase of supply must b connected 2 phase of charger...?