why normally Generator rating are between 11Kv to 22Kv?
Answer Posted / ajay
You can have generation voltage less than 11kV like 3.3kV,
6.6kV etc but normally not more than 22kV because at higher
voltages rotor insulation at high speed is practically very
difficult to manage.
Is This Answer Correct ? | 23 Yes | 6 No |
Post New Answer View All Answers
what is PWM in IGBT and how it works for drive.?
along with technical test papers
condition Autotrip facia come on control panel of electrical transmission line?
why US countries maintains 110v and 60HZ
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
by what factor the starting current is used when comparing star and delta connection for motor starting?
is the value of inductance depends upon the value of thitha in doubly excited machine??
i want to model paper for section engg.
hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly
Which type of air compressor is used now a days in the market. Keeping in mind of energy efficiency and maintenance points. Relevant documents may also be sent on mentioned email ids.
if sf6 gas low in gis what will happen
In parallel operation time both NGR’s close or not close if both close what will happen
Why neutral point is consider as zero potential?
Difference between drift current and diffusion current?
we have 2.2kw,Y,3000rpm motor but 6leads found in TB what happen if we connect in delta?