Please provide me detail cable voltage drop calculation
- 1 Answers
- 4185 Views
- I also Faced
- E-Mail Answers
Answer Posted / arshadullah
Voltage drop for selected cable
Vd = mV * I * L/N * 1000
Where,
mV : milli Volt
I : CURRENT
L : LENGHT OF CABLE
N : NUMBERS OF RUNS
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
In HI POT test what is reason for applying the AC VOLTS and DC VOLTS in different applications what is the nessesity for this ?
what is the difference between fault current ant short circuit current?
In a synchronous motor. if start is running at high speed. What will be the starting torque : Higher Lower Zero
In a large office how do we calculate required number of light fittings, assuming fittings are 4x18W or 2x36W fluorescent fitting ?
A 400KVA transformer has 400 Hz frequency. If the frequency is changed to 50 Hz, then what will be the new KVA rating?
what is the criteria for selecting fuse rating in 1phase, 2phase & 3phase welding sets?
On a 6 KVA UPS we have to provide a DC MCB for Battery bank of 16 nos (12 V 42 AH). What Shall be the current rating of DC MCB ?
How convergengr of nr method is not dependent on selection of slack bus and how gauss siedel method depends?
1.what is the reason for transformer and lightning arrester blast in 33kv system
what is the illumination level required for child play area?
how many parameters can integrate with fire alarm basically ?
I HAVE A INCOMING 100A MCCB TPN 25KA, CABLE LENGHT OF 80M 70MM CABLE SIZE FROM MAIN SUBBOARD TO NEW DB.BASE ON THE FAULT LEVEL SETTING OF 45KA.I WOULD LIKE TO FIND OUT 25KA ENOUGH KA. APPRECIATE IF SOMEBODY CAN ASSIST ME WITH FORMULA FOR THIS. FRM: JEFF
1.why we are using blocks in withoutgaplightning arrester 2.why we ar using bushing in withoutgap lightning arrestor
How the setting of the vector surge relay shall be calculated when the relay is to be used for Grid islanding application?
how to find ratio of CT & PT in 66/11kv 12 mva supply system ? explain with calculation.
