What is the accepted silt content in sand for concreting
purpose by volume method?
- 10 Answers
- 14541 Views
- I also Faced
- E-Mail Answers
Answer Posted / j.pandiyarajan
it should not be more than 8% by its volume
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
hoe much fine & sourse agregate required for concrete mix of 1: 1.5:3 by volume in Cu.Ft
Soil bearing capacity formula
I am a civil engineer . I am also selected for sbi clerk interview which is to be held on 4th May2010 is there anybody resembling the same? what question can be asked and what should be the probable answers?
How can we make a hole in a solid rectangle using solidsworks?
How much cement will require for 1Rmt Skirting laying
WAP to print 1) 1 1 1 1 1 1 1 1 1 1 2) 1 2 3 4 5 6 7 8 9 10
A super elevation of 60 cm has been provided on a 8m wide road and a curve of 260m radius .calculate the max.speed in km/hr of the vehicle that can be negotiated safely? Plz answer with full solution.thanx
A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.
in levelling operation the first site on any change point is back site the second site on any change point is fore site the line commenses with fore sight & closes with backsight the line comensses with back sight & closes with fore sigh
what are the cube & Sylinder strength of concret M20,M25,M30,M35,M40,M60 ,M75,M10 ,M15
Why M15 is replaced by M20 when ammendment are made in IS456 in 2000?
pls give me some basic informations in construction of a structure?
1. HOW MUCH CEMENT AND SAND REQUIRED TO PLASTER 100 SQM WALL. 2. HOW MUCH CEMENT AND SAND REQUIRED FOR SCREED WORK OF AREA 30 SQM
questions with answers to face an interview of an civil engineer regarding RCC buidings
Pls explain me about tension and compression in a flat slab
