if i change range of flow transmitter in th field then does
it need to change range in dcs?
- 3 Answers
- 7255 Views
- I also Faced
- E-Mail Answers
Answer Posted / www.islamqa.com
we have to configure the range in dcs with the new values.
example:
old range:
o - 625 "wc means 4ma at 0, 20 ma at 625
new range:
0 - 2500 "wc means 4 ma at 0, 20 ma at 2500
Regards,
Ahmed Sabry
Control and Instrumentation Engineer
GPC - General Petroleum Company
ahmedsabry.online@gmail.com
CELL.: 00 2 0121367310
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
what is the reason while warning lamp is on while the engine is cranking?
what is function of SCADA , and how is it work, explain with difination
Can I calibrate the Electromagnetic Flow Meter on line and How.
I faced several time siemens ps2 positioner automatically getting Chang in it's set point direction after auto calibration So is there any causes biside this or any permissives ?
what are the steps I have to deal with?
hii my name is sujith...i am preparing for HPVL GET 2010... so ,,,pls help me by send any previous questions or material to my site.....(Msujith_12@in.com) thank q
Hi Friends i need Electronics&Instrumentation Engg question papers for BARC written test by coming 20th May 2008 pls post ur use full info to kkumarei@gmail.com. Or for suggestions pls give one missed call to 9962122264
Name different parts of a pressure gauge. Explain the use of hair spring in the pressure gauge.
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
what would be the minimum flow rate that we can measure on rotameter..?
What is the diffrence between ff tx and non ff tx
what is zero and span ?
where i can get training in INTOOLS and PDMS in Delhi-NCR OR north part of India. please reply with ur ans. at arunsamkaria@ymail.com
find the kp ki kd from the transper function G(S)=29.44s+04707/1.5349s2+s
Why rdt and thermocouple both give different output .and one things more, how to generate ohm or mili volt plz mail me merajalam143545@yahoo.com
